¶ DIN Rails
BringAuto Pi can be easily mounted to the DIN rail by appling DIN mount instead standard BringAUto Pi Holder.
Data Sheet
Monted DIN holder
¶ Tested DIN mount
Any DIN compatible holder can be used. Colsult with BringAuto Pi Enclosure drawing.
¶ Tested DIN holders
- Bopla 22035000 (available on TME or BringAuto Tindie)
¶ DIN mount application manual
Make sure the DIN holder orientation is correct!
- Disassemble Top, Bottom and Raspberry Pi
- carefully disconnect ethernet cable from Watchdog board
- prepare Bopla holder (or any equivalent one)
- insert screws
- tighten screws (do not use execive force!)
- Connect etnernet cable, assemble Raspberry Pi and close Enclosure the inverse way how the disassemble proceeded - Disassemble Top, Bottom and Raspberry Pi
¶ DIN mount - simple
In case when the higher durablity is not required DIN mount can be assembled by two M3x8 screws
without disassembly of the BringAuto Pi.
- use thread inset at the bottom part of the BringAutoPi
- tighten screws firmly!
